800.354.8556
+1 503.598.4564
  Search
Veris Industries
 
Build-A-Sensor
Build A CO2 Sensor
Build A Humidity Sensor
Build A Temperature Sensor
LEED
Field Support
Electric Motor Estimators
Links
Protocol Info
Modbus
BACnet
LonWorks
SNMP
Home >  Design Resources > Ultrasonic Flow Meter Configuration
Ultrasonic Flow Meter Configuration
Veris strives to make your Ultrasonic Flow Meters easy and quick to install, keeping your costs low. We can pre-program the meter with the information on this configuration page. If you don't want the device pre-programmed, or if you don't know the installation information, then indicate this using the checkbox. The monitor is easily programmed on site, using either the keypad or the Ultrasonic Programming Software (USP, optional). For specific product information, refer to the appropriate section in the manual or contact Veris Technical Support.
Click here for a PDF of information shown below.
(Red fields below are required)
Company Name:    
Customer PO:    
Job Name:    
Specified By (Name):    
E-mail Address:    
Veris Customer Order #:    
Please complete this form in its entirety for each meter purchased.
Meter #:  
Monitor Display Model:  
Transducer Model:  
No Meter Programming:
Display Units after Programming:  
Pipe Material:  
Pipe Outside Diameter
(0.001 to 99.000 inches):
 
Pipe Wall Thickness
(0.001 to 11.000 inches):
   
Liner Material:  
Liner Material Thickness
(0.000 to 11.000 inches):
   
Fluid:  
Flow Rate Units:  
Flow Rate Time Units:  
Totalizer Units:  
Totalizer Units Exponent:  
Minimum Flow Rate
(0.000 to 45000.000):
   
Maximum Flow Rate
(0.001 to 45000.000):
   
Customer Notes:
(250 characters max.)